HIKVISION DS-2DF8C435MHS-DELW - Page 58

2.
Check Enable Supplement Light.
3.
Click Save.
4.
Go to Conguraon → Image → Display Sengs → Day/Night Switch to set supplement light
parameters.
Smart Supplement Light
This feature uses smart image processing technology to reduce overexposure caused by
supplement light.
Supplement Light Mode
When the mode is set to Auto, the supplement light is
automacally turned on or o
according to the image brightness. You can enable White Light Enhancement and White Light
Brightness is adjustable.
When the mode is set to Manual, you can adjust the Low Beam, Medium Beam, and High
Beam brightness of IR Light and White Light.
Brightness Limit
Adjust the upper limit of supplement light power.
Note
The funcon varies on device sengs and device models.
BLC
If you focus on an object against strong backlight, the object will be too dark to be seen clearly. BLC
(backlight compensaon) compensates light to the object in the front to make it clear. If BLC mode
is set as Custom, you can draw a red rectangle on the live view image as the BLC area.
HLC
When the bright area of the image is over-exposed and the dark area is under-exposed, the HLC
(High Light Compression) funcon can be enabled to weaken the bright area and brighten the dark
area, so as to achieve the light balance of the overall picture.
WDR
The WDR (Wide Dynamic Range) funcon helps the camera provide clear images in environment
with strong
illuminaon dierences.
When there are both very bright and very dark areas simultaneously in the eld of view, you can
enable the WDR
funcon and set the level. WDR automacally balances the brightness level of the
whole image and provides clear images with more details.
Network Speed Dome User Manual
46