HIKVISION DS-2TD2667-35/PY

Thermal & Optical Bi-spectrum Network Camera User Manual
50
9.6 Set Manual DPC (Defective Pixel Correction)
If the amount of defective pixels in the image is comparatively small and accurate correction is
needed, you can correct these pixels manually.
Steps
1. Go to Configuration → Image → DPC.
2. Select the thermal channel.
3. Select manual mode.
4. Click the defective pixel on the image, then a cursor shows on the live view.
5. Click Up, Down, Left, Right to adjust the cursor position to the defective pixel position.
6. Click , then click to correct defective pixel.
Note
If multiple defective pixels need to be corrected, click after locating a defective pixel. Then
after locating other pixels, click to correct them simultaneously.
7. Optional: Click to cancel defective pixel correction.
9.7 Set Picture in Picture
You can overlay the images of two channels and view the image of two channels at the same time.
Steps
1. Select a channel number.
2. Select the picture in picture mode.
Overlap Mode
Partial image of thermal channel is displayed on the full screen of
optical channel. This mode is only supported in optical channel.
Details Overlay
Mode
The device displays the details of optical channel on thermal channel.
This mode is only supported in thermal channel.
3. In Details Overlay Mode, set the Fusion Distance of the target. It is recommended to use the
default value.
4. Click Save.
Note
Not all models support this function, take the actual product for reference.