7.1.3 Manual Thermography
After enable the manual thermography function of the device, you can click any position on
the live view to show the real temperature.
Steps
1.
Go to Conguration > Local and select Display Temperature Info. as Yes.
2.
Go to
Conguration > Temperature Measurement & Fire Prevention > Basic Settings .
3.
Check Enable Temperature Measurement.
4.
Click Save.
5.
Go to live view interface and select thermal channel, click
. Click any position on the
interface to show the real temperature.
7.2 Fire and Smoke Detection
The device will trigger and upload alarm when detect the re source or smoke.
The detection is applied to re-prevention purposes in scenic region, forest, tunnel and so
on. You can
congure the detection parameters. When re source or smoke is detected,
the alarm actions will be triggered.
Note
Not all models support the function. Please take the actual product for reference.
7.2.1 Recommended Scene
This part introduces the recommended scenes of re source detection and helps you
select the appropriate scene.
Fire source detection can be applied to indoor and outdoor monitoring with a large
detection radius. To achieve the best monitoring effect, please set the installation place as
requirements below.
●
The installation place should be the highest position within the detection area. The lens
should not be covered during movement to detect the maximum area.
●
It is better to choose the installation place with convenient
trafc, well-equipped power
and internet facilities (e.g., communication tower, watchtower and high-rise roof).
7.2.2 Set Fire and Smoke Detection
To avoid the potential re source and smoke damage simultaneously, you can congure
the function for certain areas. The detail conguration steps show as below.
Thermal & Optical Bi-spectrum Network Camera User Manual
62
To Next Page
Loading...
Need help?
General
