Alarm Output Self-check
You can enable the function to regularly self-check the connection between the device and
the alarm server.
Steps
1.
Check Enable Auto Trigger.
2.
Set Trigger Time, and the device will trigger an alarm output to the alarm server
automatically in the set time.
3.
Set Auto Trigger Delay. It refers to the time duration that the alarm output remains in
effect after the auto trigger.
4.
Click Save.
9.2.2 FTP/NAS/Memory Card Uploading
If you have enabled and congured the FTP/NAS/memory card uploading, the device
sends the alarm information to the FTP server, network attached storage and memory card
when an alarm is triggered.
Refer to
Set FTP
to set the FTP server.
Refer to
Set NAS
for NAS conguration.
Refer to
Set Memory Card
for memory card storage conguration.
9.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
information when an alarm event is detected.
For email settings, refer to
Set Email
.
Set Email
When the email is congured and Send Email is enabled as a linkage method, the device
sends an email notication to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email function. Go to Conguration > Network > Basic
Settings > TCP/IP for DNS settings.
Steps
1.
Go to email settings page:
Conguration > Network > Advanced Settings > Email .
2.
Set email parameters.
1)Input the sender's email information, including the Sender's Address, SMTP Server,
and SMTP Port.
Thermal & Optical Bi-spectrum Network Camera User Manual
83
To Next Page
Loading...
Need help?
General
