Figure 7-21 802.1X Settings
3. Check the Enable IEEE 802.1X checkbox to enable it.
4. Configure the 802.1X settings, including user name and password.
The EAP-MD5 version must be identical with that of the router or the switch.
5. Click to finish the settings.
The camera reboots when you save the settings.
6. After the configuration, connect the camera to the protected network.
Integration Protocol
Purpose:
If you need to access to the camera through the third party platform, you can enable CGI function.
And if you need to access to the device through ONVIF protocol, you can configure ONVIF user in
this interface. Refer to ONVIF standard for detailed configuration rules.
CGI
Check the Enable Hikvision_CGI checkbox and then select the authentication from the
drop-down list.
Note: Digest is the recommended authentication method.
ONVIF
Steps:
1. Check the Enable ONVIF checkbox to enable the function.
2. Add ONVIF users. Up to 32 users are allowed.
3. Set the user name and password, and confirm the password. You can set the user as media
user, operator, and administrator.
Note: ONVIF user account is different from the camera user account. You
have set ONVIF user account independently.
4. 3. Save the settings.
Note: User settings of ONVIF are cleared when you restore the camera.
To Next Page
Loading...
Need help?
General
