- 4 -
Chapter 2 Installation Preparation
2.1 Caution of Usage
Similar to other electronic products, the semiconductor chip easily gets damaged if
you power on or off abruptly and frequently. To restart up the switch of 24 SWITCH,
you have to open the power on-off after the power is cut down for three to five
seconds.
Avoid severe collision or falling down from the height to protect the parts in the
switch.
Do not insert the Ethernet plug into the console port (RJ45 8-line socket). Similarly,
do not insert the console cable into the console port (RJ45 8-line socket).
Note:
1) When you plug or dial the power line, keep the power line horizontal with the
power socket.
2) When the lifetime of our products ends, handle them according to national laws
and regulations, or send these products to our company for collective processing.
2.2 Safety Advice
2.2.1 Safety Principles
Keep dustless and clean during or after the installation.
Put the cover at the safe place.
Put tools at the right place where they are not easily falling down.
Put on relatively tight clothes fasten the tie or scarf well and roll up the
sleeve, avoiding stumbling the machine box.
Put on the protective glasses if the environment may cause damage to your
eyes.
Avoid incorrect operations that may cause damage to human or devices.
2.2.2 Safety Notices
The safety notices mentioned here means that improper operation may lead to
body damage.
To Next Page
Loading...
Need help?
General