HIKVISION DS-7108HI-S Series User Manual (English)

Other manuals for HIKVISION DS-7108HI-S Series

Questions and Answers:

J
Joan ArnoldJul 29, 2025
What to do if my HIKVISION DS-7108HI-S DVR continuously reboots and makes a ticking sound?
- M
  Michelle HernandezJul 29, 2025
  If your HIKVISION DVR continuously reboots after starting up and makes a ticking sound, it could be due to several reasons. One possibility is that you upgraded the DVR with the wrong firmware, in which case you should upgrade to the correct firmware. Another potential cause is a problem with the compression board, so check the compression board. Finally, the main board could be faulty, so check it as well.
K
Kevin GonzalezAug 3, 2025
Why can't my HIKVISION DVR find the hard disk in reboot process?
- M
  Matthew JohnsonAug 3, 2025
  If you cannot find the hard disk during the reboot process of your HIKVISION DVR, check the hard disk cable first to make sure it's not broken. Then, ensure that the power cable of the hard disk is connected. If both cables are fine, the hard disk itself might be broken, so check the hard disk.
E
Ernest LawrenceAug 7, 2025
Why can't my client software view the HIKVISION DVR live image?
- X
  xwilliamsAug 7, 2025
  If your client software cannot view the live image from your HIKVISION DVR, it might be due to a network error, so check the network. Ensure you're connecting to the correct DVR with the right IP address, port number, username, and password. If you're still experiencing issues, try updating to the latest player SDK.
M
Madeline GeorgeAug 11, 2025
How to fix HIKVISION DVR when it cannot control PTZ through RS-485 port?
- J
  Justin BartlettAug 11, 2025
  If your HIKVISION DVR cannot control PTZ through the RS-485 port, first check the RS-485 cable to ensure it is correctly connected and not broken. Also, verify that the PTZ parameters are correct. If the issue persists, the RS-485 port of the DVR might be broken, so check it.
D
dana23Aug 15, 2025
What to do if there are no images on the monitor connected to HIKVISION DVR?
- P
  Parker LambertAug 15, 2025
  If there are no images on the monitor connected to the VOUT of your HIKVISION DVR after it's started, check the cable connected to the monitor. If the cable is not the issue, the real board of the DVR might have problems, so check it. Alternatively, the main board of the DVR could be faulty, so check the main board.

HIKVISION DS-7108HI-S Series Specifications

General

Video Input	8 channels
Compression	H.264
Power Supply	12V DC
USB Interface	2 USB 2.0 ports
Power Consumption	≤ 10W
Operating Temperature	-10°C to +55°C
Operating Humidity	10% to 90%
Video Output	VGA
Recording Resolution	CIF/QCIF
Storage	1 SATA interface
Network Interface	1 RJ45 10M/100M Ethernet interface
Audio Compression	G.711
Audio Input	1-ch
Audio Output	1 channel
Frame Rate	25 FPS (PAL), 30 FPS (NTSC)
Playback Resolution	CIF/QCIF