HIKVISION DS-7600 Series Quick Start Guide

Using Internet Explorer
All Hikvision products use the default IP address of 192.0.0.64
1. Connect a CAT5 or CAT6 cable from the DVR to a PC or Laptop computer.
Note your laptop or PC computers existing address, such as:
IP: 192.0.0.62
Subnet: 255.255.255.0
2. Open Internet Explorer.
3. In the address bar, type 192.0.0.64
If prompted, allow the installation of the Hikvision application.
It may be necessary to add this IP address as a Trusted Site with Low Security.
4. Login to the DVR:
Name: Admin
Password: 12345
Port: 8000
5. Go to the Config tab, then Remote Config, then [Network Parameters] Parameters Configuration.
6. Click on Network Settings.
7. Enter the IP address you wish the DVR to have, then SAVE, then Cancel to Exit.
8. Reset your laptop or PC to its original IP address, subnet and gateway.
9. Type the new address in Internet Explorer.
Using Hikvision iVMS 4000 software
If possible, check www.hikvisionusa.com/downloads.html for the latest version of the iVMS4000 software.
If internet access is not available, install the software from the CD.
Then follow the instructions included with the software.
Network Connection
9. DVR Network Connection
First Choice For Security Professionals

HIKVISION DS-7600 Series Specifications

General

Video Output	BNC
Compression	H.264
Network Interface	RJ-45
USB Interface	2 × USB 2.0
VGA Output	1 channel, up to 1920x1080 resolution
Operating Temperature	-10 °C ~ +55 °C (14 °F ~ +131 °F)
Operating Humidity	10% ~ 90%