4. Formatting a Disk (cont.)
3. Click the Add button.
4. A confirmation message will appear on the screen.
Click the Yes button to continue formatting process.
5. A format progress bar will be shown on the menu.
After the disk has been formatted, the status of the
disk will change to Active.
6. Click the Done button to exit out of Disk Management.
5. Setting Date & Time
1. Enter the Time/Date menu by going to Main Menu
> System Configuration > Time/Date.
2. Enter the correct date and time.
3. Click the Save button to save the setting.
To setup date and time:
HYBRID DVR/NVR/ANALOG
To Next Page
Loading...
