10. Add IP Cameras
Adding IP Cameras
1. Enter the Add/Remove Cameras menu by going to Main Menu > Cameras Setup > Add/Remove Cameras.
2. Select the IPC tab.
3. Click the Discover button to automatically detect connected IP cameras on the network.
4. If the detected IP cameras and DVR are not on the same subnet, you can modify the cameras’ IP,
subnet and port settings.
5. Click the Test Connection button to test if the IP camera was connected successfully or not.
6. Click the Add button to add the IP camera to the Added Cameras list.
7. Once an IP camera has been added to the Added Cameras list, you may remove the camera by clicking
the Trashcan icon or view the camera by clicking the Play icon.
8. Click the Done button to save settings and return to the previous menu.
9. Go to Main Menu > Recording Configuration > Recording Quality Settings to setup IP camera
recording resolution, frame rate, etc.
1. Connect to the DVR by typing the IP address in the address bar
2. Login to the DVR as above.
3. Click on Config > Remote Config > IP Camera
4. Enter the camera IP Address and other appropriate information on the right side of the screen.
5. Click Modify to save your settings.
6. Repeat to add more cameras.
Directly on the Hybrid DVR and NVR’s Menu:
Using Internet Explorer
HYBRID DVR/NVR/ANALOG
To Next Page
Loading...
Need help?
General
