Network Video Recorder User Manual
117
Step 1 Go to System > Event > Smart Event.
Step 2 Click Vehicle.
Figure 12-3 Vehicle Detection
Step 3 Select a Camera to configure.
Step 4 Check Enable Vehicle Detection.
Step 5 Optionally, check Save VCA Picture to save the captured pictures of vehicle detection.
Step 6 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 7 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 8 Configure rules, including Area Settings, Picture, Overlay Content, and Blacklist and
Whitelist. Area Settings: Up to 4 lanes are selectable.
Step 9 Click Save.
Refer to the User Manual of Network Camera for the detailed instructions for the vehicle
detection.
12.4 Line Crossing Detection
Purpose
To Next Page
Loading...
