User Manual of Embedded Net DVR
Page 22 Total 113
13 PTZ Same PTZ key of front panel.
14 ESC Same as ESC key of front panel.
15 Reserved
16 F1 Same asF1key of front panel.
17 Lens control
IRIS, FOCUS ZOOM for lens
control.
18 F2 Same asF2key of front panel.
Loading the batteries into the IR controller
1. Remove the battery cover.
2. Insert the battery. Please take care that the poles (+ and -) are correctly positioned.
3. Replace the battery cover.
Start to use IR controller
PressDEVkey, input the DVR device ID (default is “88”, can be changed in “Display” menu)
and then pressENTERkey. If the “STATUS” lamp of DVR front panel is turned into green, it
means you can use IR controller to operate this DVR.
Stop using IR controller
When IR controller status is on, pressDEVkey again, the “STATUS” lamp will be turned off.
The IR controller can not control this DVR.
Switch the DVR off
When IR controller status is on, pressPOWERkey for several seconds, the DVR will be
powered off.
When IR controller can not work normally
z Check batteries poles.
z Check the remaining charge in the batteries.
z Check IR controller sensor is mask.
Please change another IR controller to try again. It the problem is still existed, please contact
administrator.
To Next Page
Loading...
