User Manual of Embedded Net DVR
Page 66 Total 113
5.12 Recording Setup
In main menu, there is an icon named “Recording”. You can enter into recording menu as
following:
“Recording” menu description:
If HD Full: There are two options: “Overwrite” and “Stop recording”. If you select
“Overwrite” option, when all HDDs in DVR are full, DVR will overwrite the earliest recorded files
and continue recording. If you select “Stop recording” option, when all HDDs are all full, DVR will
handle it as “Hard Disk Full” exception, please refer to chapter 5.17 for exception menu.
Select Camera: Here all channels are listed. You can use↑↓keys to select one.
Stream Type: There are two options, one is “Audio&Video” stream and the other is “Video”
stream only. If you want to record video and audio, please select “Audio&Video” option, otherwise
you can select “Video” option to record only video. For DS-8000HSI DVR, there is only one
“Video” option.
Note: If you change this option, please reboot DVR to make parameter into effective.
Resolution: The higher resolution is, the clearer the image is. The resolution options from low
to high are: QCIF, CIF, 2CIF, DCIF, 4CIF.
For DS-8000HCI series DVR: Only 1
st
, 5
th
, 9
th
and 13
th
can support QCIF, CIF, 2CIF, DCIF and
4CIF resolution, other channels can only support QCIF and CIF resolution.
For DS-8000HSI series DVR: All channels can only support QCIF and CIF resolution.
For DS-8000HTI series DVR: All channels can support QCIF, CIF, 2CIF and DCIF resolution.
For DS-8000HFI series DVR: All channels can support QCIF, CIF, 2CIF, DCIF and 4CIF
resolution.
Note: If you change this resolution option, please reboot DVR to make it into effective.
To Next Page
Loading...
Need help?
General