User Manual of Embedded Net DVR
Page 33 Total 113
Light control key: LIGHT/F1;
Auxiliary device control key:AUX/F2
Adjust preset description
In PTZ control mode, pressREC/SHOTkey, and press the preset number (three numeric keys),
DVR will adjust the corresponding preset number. Repeat pressingREC/SHOTkey, and press the
preset number, DVR will adjust that preset number.
When you exit PTZ control mode, the camera will stay at the current position.
Note: The PTZ preset number is set already. Please refer to PTZ menu for preset setup. V1.4
firmware can support 128 preset number at most.
Start/Stop auto in PTZ control mode
In PTZ control mode, press PLAY/AUTO key to start PTZ auto function. Press
PLAY/AUTOkey again to stop.
When PTZ is in auto mode, if you exit PTZ control mode, PTZ will continue auto
function.You must enter into PTZ control mode again, and pressPLAY/AUTOkey to stop.
Exit PTZ contrl mode
PressESCorENTERto exit and return preview mode.
To Next Page
Loading...
