User Manual of Embedded Net DVR
Page 63 Total 113
Step 5: Motion alarm policy: Move “Active Frame” to the corresponding “Policy” button of
motion detection alarm, pressENTERkey to enter into “Motiomn Alarm Handle” menu:
Step 6: Motion alarm record channel setup: When there is motion alarm happened, you can
trigger related camera to start recording. In “Motion Alarm Handle” menu, you can select one or
more record channels. Please useENTERorEDITkey to enable the flag into “9”.
Note: In order to make the cameras start recording, in “Recording” menu, you must enable
recording schedule and set “Rec Type” as “Motion Detection” or “Motion | Alarm”. Please refer to
chapter 5.12 for recording setup.
Step 7: Motion alarm schedule: When the motion alarm is happened in schedule, DVR will
response such as “On Screen Warning”, “Audible Warning”, “Upload to Center” and “Trigger
Alarm Output”. You can setup 4 time periods for one day and 7 days for one week.
Note: Time periods in one day can not be repeat.
Step 8: Motion alarm handle method setup: You can select one or more handle methods such
To Next Page
Loading...
