Network Video Recorder User Manual
122
Step 8 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 9 Click Apply.
12.5 Region Entrance Detection
Purpose:
Region entrance detection function detects objects that enter a pre-defined virtual region from the
outside place.
Step 1 Go to System Management > Event Settings > Smart Event.
Step 2 Click the Region Entrance Detection item.
Figure 12-6 Region Entrance Detection
Step 3 Select a Camera to configure.
Step 4 Check Enable Region Entrance Detection checkbox.
Step 5 Optionally, check Save VCA Picture checkbox to save the captured pictures of region
entrance detection.
Step 6 Follow the steps to set the detection rules and detection areas.
7) Select an Arming Region to configure. Up to 4 regions are selectable.
8) Drag the sliders to set Sensitivity.
Sensitivity: The higher the value is, the more easily the detection alarm can be triggered.
Its range is [0-100].
To Next Page
Loading...
