HIKVISION DS-96000NI-I16 Series: DS-96000NI-I16/H Series - Restore Default Settings; System Service; Network Security Settings

Network Video Recorder User Manual
155
16.6 Restore Default Settings
Step 1 Go to Maintenance > Default.
Figure 16-11 Restore Defaults
Step 2 Select the restoring type from the following three options.
Restore Defaults: Restore all parameters, except the network (including IP address, subnet
mask, gateway, MTU, NIC working mode, default route, server port, etc.) and user account
parameters, to the factory default settings.
Factory Defaults: Restore all parameters to the factory default settings.
Restore to Inactive: Restore the device to the inactive status.
The device will reboot automatically after restoring to the default settings.
16.7 System Service
16.7.1 Network Security Settings
Disabling SADP Services
Purpose
You can disable SADP service to enhance the access security, e.g., when you are in the untrusted
network environment.
Step 1 Go to System > System Service > System Service.
Step 2 Uncheck Enable SADP to disable the service.