Network Video Recorder User Manual
82
8.2.3 Manually Rebuild Array
Purpose:
If no hot spare disks are configured, rebuild the degraded array manually.
Before you start:
At least one available physical disk should exist for rebuilding the array.
Step 1 Go to Storage > RAID Setup > Array.
Figure 8-6 Array List
Step 2 Click of degraded array.
Figure 8-7 Rebuild Array
Step 3 Select the available physical disk.
Step 4 Click OK.
Step 5 Click OK on the pop up message box “Do not unplug the physical disk when it is under
rebuilding”.
To Next Page
Loading...
