HIKVISION DS-D5055UL-B - Chapter 3 System Configuration; Input Source Selection; Image Parameters; Configuring Image Mode

LCD Monitor User Manual
8
Chapter 3 System Configuration
Input Source Selection 3.1
Before you start:
Turn on the display unit when the power supply and the input signal are available.
Press SOURCE on the remote controller to enter the menu. Five input sources are selectable: Step 1
VGA, CVBS, HDMI, DVI and USB signal.
Press direction keys to select the input source. Step 2
Press OK to complete the input source selection. Step 3
Image Parameters 3.2
Configuring Image Mode 3.2.1
You can adjust the image parameters by switching image modes and adjust the values of contrast,
brightness, color, sharpness and hue.
On the main menu, press ◄ or ► on the remote control to enter the Image Settings page. Step 1
Press ▲ or ▼ to select the Image Mode item. Step 2
Press OK. Step 3
Image Mode Figure 3-1
Press ◄ or ► to switch it to Standard/Soft/Natural/Vivid/Sports/Lightness/User mode. Step 4
Configure the image parameters. Step 5