LCD Monitor User Manual
10
Configuring Overscan 3.2.4
Overscan is the situation in which not all of an image is present on a viewing screen. You can shield
the borders for better image quality by adjusting the overscan value of up/down/left/right.
On the main menu, press ◄ or ► on the remote control to enter the Image Settings page. Step 1
Press ▲ or ▼ to select the Overscan item. Step 2
Press OK. Step 3
Press ◄ or ► to set the values of the left edge, right edge, top edge and bottom edge from Step 4
0 to 100. The value of overscan is the pixel value of certain edge.
Overscan Settings Figure 3-4
Press MENU again to complete the settings. Step 5
Configuring VGA Parameters 3.2.5
For VGA input source, you can adjust the VGA parameters, including adjusting row, column, clock
and phase values of the VGA signal.
Manual Adjustment
The VGA parameter settings are valid only for the VGA input source.
On the main menu, press ◄ or ► on the remote control to enter the Image Settings page. Step 1
Press ▲ or ▼ to select the VGA Parameters item. Step 2
Press OK. Step 3
Press ◄ or ► to set the values of the Row, Column, Clock and Phase from 0 to 100. Step 4
To Next Page
Loading...
