HIKVISION DS-K1T673 Series - Advanced Configuration

9.5.3 Set Time
Set the device's me, me zone, synchronizaon mode, server address, NTP port, and interval.
Click
Conguraon → System → System Sengs → Time Sengs .
Figure 9-1 Time Sengs
Click Save to save the sengs aer the conguraon.
Time Zone
Select the device located me zone from the drop-down list.
Time Sync.
NTP
You should set the NTP server's IP address, port No., and interval.
Manual
By default, the device
me should be synchronized manually. You can set the device me
manually or check Sync. with Computer Time to synchronize the device me with the
computer's
me.
Server Address Type/Server Address/NTP Port/Interval
You can set the server address type, server address, NTP port, and interval.
9.5.4 Set DST
Steps
1.
Click
Conguraon → System → System Sengs → Time Sengs .
DS-K1T673 Series Face Recognion Terminal User Manual
95