HIKVISION DS-K1T673 Series - Authenticate Via Multiple Credential; Basic Settings

Enter the password to authencate via password.
Keyfob
Press door-open buon to authencate.
If authencaon completed, a prompt "Authencated" will pop up.
7.5.2 Authencate via Mulple Credenal
Before You Start
Set the user
authencaon type before authencaon. For details, see Set Authencaon Mode .
Steps
1.
If the authencaon mode is Card and Face, Password and Face, Card and Password, Card and
Face and Fingerprint,
authencate any credenal according to the instrucons on the live view
page.
Note
●
The card can be normal IC card, or encrypted card.
●
If the QR Code Scanning funcon is enabled, you can put the QR code in front of the device
camera to authencate via QR code.
2.
Aer the previous credenal is authencated, connue authencate other credenals.
Note
●
For detailed informaon about scanning ngerprint, see Tips for Scanning Fingerprint.
●
For detailed informaon about authencang face, see Tips When Collecng/Comparing Face
Picture.
If authencaon succeeded, the prompt "Authencated" will pop up.
7.6 Basic
Sengs
You can set sound sengs, me sengs, sleeping (s), community No., building No., Unit No.,
beauty, privacy, authencaon indicator, video standard and secure door control unit.
Long tap on the
inial page for 3 s and slide to the le/right by following the gesture and login the
device home page. Tap System → Basic .
DS-K1T673 Series Face Recognion Terminal User Manual
69