HIKVISION DS-K3G200LX-R/Dm55 - Chapter 5 Activation; 5.1 Activate via SADP

Note
●
The cable bare part should be no more than 8 mm. If possible, wear an insulaon cap at the end
of the bare cable. Make sure there's no bare copper or cable aer the wiring.
●
The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output
terminal reversely.
●
To avoid people injury and device damage, when tesng, the ground resistance of the
equipotenal points should not be larger than 2 Ω。
4.3 Wiring
Scan the QR code to view the wiring guide video.
4.4 Terminal
Descripon
4.4.1 Lane Control Board Terminal Descripon
The lane control board contains power input interface, exit buon and re input interface, access
control board interface, debugging port, indicator interface, etc.
The picture displayed below is the lane control board diagram.
DS-K3G200(L)X Series Tripod Turnsle
10