Need help?Do you have a question about the HIKVISION DS-KV8102-IP and is the answer not in the manual?
General| Color | Yes |
|---|---|
| Video codecs | H.264 |
| Certification | FCC, IC, CE, C-TICK, ROHS, REACH, WEEE |
| Number of buttons | 1 buttons |
| Connectivity technology | Wired |
| Sustainability certificates | RoHS |
| Voice codecs | G.711u |
| Megapixel | 1.3 MP |
| Sensor type | CMOS |
| Maximum frame rate | 25 fps |
| Maximum video resolution | 1280 x 720 pixels |
| Proper use | Outdoor |
| Product color | Gray |
| Outdoor unit housing material | Plastic |
| International Protection (IP) code | IP65 |
| LED type | IR |
| Outdoor unit power type | AC/DC |
| Power consumption (typical) | 12 W |
| Operating relative humidity (H-H) | 10 - 90 % |
| Door station operating temperature (T-T) | -40 - 70 °C |
| Operating system installed | Linux |
| Cabling technology | 10/100Base-T(X) |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Ethernet interface type | Fast Ethernet |
| Ethernet LAN (RJ-45) ports | 1 |
| Supported network protocols | TCP/IP, RTSP |
| Indoor unit included | No |
Weight and Dimensions| Depth | 54.4 mm |
|---|---|
| Width | 97 mm |
| Height | 164 mm |
| Door station dimensions (WxDxH) | 97 x 54.4 x 164 mm |
Highlights critical safety precautions to prevent serious injury or death.
Outlines precautions to prevent equipment damage or minor injury.
Provides instructions and diagrams for connecting various components to the door station.
Explains how to wire the door lock and electric bolt/strike to the door station.
Provides step-by-step instructions for installing the DS-KV8X02-IM door station.
Details the process of wall mounting the DS-KV8X02-IM door station using a gang box.
Guides on how to remotely activate the door station by setting a strong password.
Explains how to remotely modify the network settings (IP address, gateway) of the device.
Covers remote configuration of device settings through the Batch Configuration Tool.
A tool for assigning, activating, and configuring devices for video intercom systems.
Covers configuration for main and sub door stations, including building numbers.
Details the configuration steps for the main door station.
Explains how to configure sub door stations and link them to main stations.
Provides methods for upgrading device firmware in batches.
Manages devices within the iVMS-4200 software, including activation and addition.
Details how to add online or manually configured video intercom devices to the software.
Provides methods to reset device passwords via the iVMS-4200 software.
Refers to section 7.4 for remote configuration steps using iVMS-4200.
Allows remote control and configuration of video intercom devices via iVMS-4200.
Enables adding, issuing, and managing access cards via iVMS-4200.
Guides on adding new resident or other cards in batch or singly.
Details adding multiple cards at once by specifying card numbers.
Explains how to issue cards to residents or staff.
Steps to issue resident cards to indoor stations.
Guides on issuing cards for non-residents like staff.
Explains two methods for canceling issued cards.
Describes the process of issuing cards to door stations or doorphones locally.
Explains how to unlock the door by swiping an issued card.
To Next Page
