HIKVISION DS-PDD12P-EG2-WE - Page 5

Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
6
Operaon Cauon and Device Maintenance
- All the electronic operaon should be strictly compliance with the electrical safety regulaons, fire prevenon
regulaons and other related regulaons in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon.
Avoid the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment
damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then
please contact the service center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon.
Avoid the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment
damage).
- Do not place the device in extremely hot (refer to the specificaon of the device for the detailed operaon
temperature), cold, dusty or damp locaons, and do not expose it to high electromagnec radiaon.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or radiator is forbidden
(ignorance can cause fire danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not
a malfuncon however), and affecng the endurance of sensor at the same me.
- Improper use or replacement of the baery may result in hazard of explosion. Replace with the same or
equivalent type only. Dispose of used baeries according to the instrucons provided by the baery manufactur-
er.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situaon.
The detector will enter the walk test mode (3 minutes) aer being enrolled.
Trigger the detector within the detecon range.
If the LED indicator turns blue, the installaon posion is properly. If the LED indicator is sll off, adjust the posion of the detector.
3min
5
Formang
Hold the tamper switch for 8 s and power the device on at the same me. The red LED flashes 3 mes when the formang
operaon is completed.
5