HIKVISION DS-PDMCK-EG2-WE - Page 2

Dig the groove to disassemble the device. Remove the front and rear panel. Turn the power switch to ON to power on the device.
Note: Do not disassemble the device with sharps.
3
Power On
4
Enrollment
1
Enroll the Peripheral Locally
2
Enroll the Peripheral with QR and serial No.
1. Log in to the APP Store, download and install the App.
2. Power on the security control panel.
3. Log in the APP and tap the icon "+" . Scan the QR code or input the control panel serial No. to add the control panel.
1. In the APP, tap the "Enrollment Mode" buon on the control panel page to make the control panel enter the
enrollment status.
2. Power on the peripheral, and it will be automacally enrolled to the control panel.
1. In the APP, tap the icon "+"and scan the QR code or serial No. on the peripheral.
2. Power on the peripheral, and it will be automacally enrolled to the control panel.
CAUTION
IF THE BATTERY COMPARTMENT
DOES NOT CLOSE SECURELY,
STOP USING THE PRODUCT AND
KEEP IT AWAY FROM CHILDREN.
xxxx
Device
5
Test
The contact starts test automacally aer being enrolled to the AX PRO. The LED turn red.
Separate the contact, and make a gap between the sensor and magnet. while the LED turns green, the alarm is triggered by this gap. Adjust the installaon
posion of the contact to get a sasfied alarm gap.
The alarm will be triggered while the gap between the sensor and magnet is bigger than that shows in the table. The LED keeps blue for 2 s.
Magnet Detecon Performance Table
2
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
11 13
15 17
11 13
15 19
33 28
28 23
43 42
40 38
37 35
32 30
Without Nominal Distance With Nominal Distance 5mm
Distance in Air Distance in Air
Remove
Approach
Remove
Approach
Remove
Approach
Remove
Approach
Remove
Approach
Event
X+
X-
Y
Z+
Z-
Axes of
Operaon
Magnet Test
1