69
keypads, keyfobs, and APP. If it is not enabled, there will be no fault detection before arming.
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → Arming Options to enter the page.
You can set the following parameters:
Fault Checklist when Arming
Check the faults in the checklist, and you can manually stop arming if fault occurs.
Fault Voice Prompts on Arming
The system will make voice prompts when arming.
Fault Voice Prompts on Disarming
The system will make voice prompts when disarming.
3. Tap Save.
Enrollment Mode
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → Enrollment Mode to enter the page.
3. Tap Enter the Enrollment Mode. You can enroll the peripheral by triggering it.
Regional Certification
Tap → System → System Options → Regional Certificate to enter the page.
PD6662 is applicable to the UK market. If this function is enabled, the arming function and alarm
logic of the control panel will change.
PD6662
Enable PD6662 standard. Functions that do not meet the standard will not take effect.
Communication Fault Sending Delay
The delay time while the ATP communication fault reports to ARC.
Network Camera
Add Cameras to the AX PRO
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Network Camera → Network Camera Channel to enter the page.
To Next Page
Loading...
Need help?
General
