Fall Detection Radar • User Manual
7
Detection Boundary
Click Parameter Settings to set the radar status.
Enter standby mode
The radar will be standby and stop emitting electromagnetic waves. If the radar is powered
off and does not receive wakeup command after powered on again, then it will still be
standby mode.
Awake
If the radar is powered off, the awake mode will be kept after it is powered on again.
Falling Indication
When the radar detects a person, the left icon will be highlighted. When the radar detects the
target falls, the right icon will be highlighted.
Falling Indication
Upgrade
You can upgrade the firmware version.
To Next Page
Loading...
