HIKVISION HWN-4216MH - 6.3.2 Display Settings

Note
If you turn o Auto Add Network Camera, when an inacve network camera or third party
ONVIF camera is connected to your network, the video recorder would automacally detect it
and nofy you to add it.
Edit Connected Network Camera
You can edit the IP address, protocol and other parameters of the added network cameras.
Steps
1.
Go to
Conguraon → Camera → IP Camera .
2.
Click of an added network camera.
Channel Port
If the connected device is an encoding device with
mulple channels, you can choose the
channel to connect by selecng the channel port No. in the drop-down list.
3.
Click OK.
Example
Enter an example that illustrates the current task
(oponal).
What to do next
Enter the tasks the user should do aer nishing this task (oponal).
Upgrade Network Camera
The Network camera can be remotely upgraded through the device.
Before You Start
●
Ensure you have inserted the USB ash drive to the device, and it contains the network camera
upgrade rmware.
●
Ensure your network camera is on the same network segment with your video recorder.
●
Ensure the network
connecon is valid and correct.
Steps
1.
Go to Conguraon → Camera → Camera .
2.
Click
.
3.
Click Yes to conrm.
4.
Select the camera upgrade rmware from your storage device.
5.
Click Upgrade to start upgrading. The camera will restarted automacally aer upgrade
completed.
Network Video Recorder User Manual
52