iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 96
Steps
1. Go to Configuration → Queue Management.
2. Select Waiting Time Detection.
3. Click Add Region to draw the detection area and set Region Name, and Alarm Interval. Repeat this step
above to set more areas.
• Alarm Interval: During the set alarm interval, alarms of the same type trigger only one notification
Figure 10-3 Set Waiting Time Detection
4. Set Alarm threshold. An alarm is triggered when the alarm threshold condition is met.
5. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings, refer
to Linkage Method Settings.
6. Click Save.
7. Optional: Enable Display POS Information and Rule in Configuration →Local. The detection area and the
time people staying in the detection area can be viewed on the live view.
Queue Management Statistics
Queue management supports data analysis and report output.
Before You Start
For queue management settings, refer to Set Regional People Queuing-Up and Set Waiting Time Detection.
• Select Queuing-Up Time Analysis and Regional Comparison to compare queuing-up people number of
different regions.
• Select Queuing-Up Time Analysis and Multi-Level Comparison to compare queuing-up people number
of different waiting time levels.
• Select Queue Status Analysis and Regional Comparison to compare the time and duration that a queue
stays at a certain length in different regions.
To Next Page
Loading...
Need help?
General
