To Next PageTo Next PageWhy won't my Hiland FT-235 Patio Heater pilot stay lit?
If the pilot light won't stay lit on your Hiland Patio Heater, start by cleaning any dirt from around the pilot. Next, tighten the connection and perform a leak check. If the problem persists, consider replacing the thermocouple.
What to do if my Hiland FT-235 burner flame is low?
If the burner flame is low on your Hiland Patio Heater, first turn the cylinder valve OFF and replace the cylinder. You may also need to use a full cylinder or check the burner and orifices for any blockages. Cleaning the burner and orifices might also resolve the issue.
What to do if the pilot won’t stay lit on my Hiland Patio Heater?
If the pilot light won't stay lit, the issue could be due to: * Dirt built up around the pilot: Clean the dirt from around the pilot. * A loose connection between the gas valve and pilot assembly: Tighten the connection and perform a leak check. * A faulty thermocouple: Replace the thermocouple.
What to do if my Hiland FT-235 burner won’t light?
If the burner won't light, it could be due to several reasons. First, the propane cylinder might be frosted over; wait until it warms up. Second, there might be a blockage in the orifice; clear any blockage. Third, the control knob might not be in the ON position; turn it to ON.
What to do if my Hiland Patio Heater pilot won’t light?
If the pilot light on your Hiland Patio Heater won't ignite, it could be due to a few reasons. There might be air in the gas line; open the gas line and bleed it (pressing control knob in) for no more than 1 - 2 minutes or until you smell gas. If the gas pressure is low with the cylinder valve fully open, turn the cylinder valve OFF and replace the cylinder. You can also try using a match to light the pilot, and consider obtaining a new igniter.
General| Brand | Hiland |
|---|---|
| Model | FT-235 |
| Category | Patio Heater |
| Language | English |
