Hiland Premium F-1350-FPT User Manual (English)

Questions and Answers:

D
David FloresAug 25, 2025
What to do if my Hiland Premium F-1350-FPT Patio Heater pilot won’t light?
- T
  Theresa WilliamsAug 25, 2025
  If the pilot light on your Hiland Patio Heater won't ignite, it could be due to a few reasons. There might be air in the gas line; open the gas line and bleed it (pressing control knob in) for no more than 1 - 2 minutes or until you smell gas. If the gas pressure is low with the cylinder valve fully open, turn the cylinder valve OFF and replace the cylinder. You can also try using a match to light the pilot, and consider obtaining a new igniter.
J
Juan FloresAug 25, 2025
What to do if my Hiland Premium F-1350-FPT Patio Heater burner won’t light?
- J
  jesse51Aug 26, 2025
  If the burner won't light, it could be due to several reasons. First, the propane cylinder might be frosted over; wait until it warms up. Second, there might be a blockage in the orifice; clear any blockage. Third, the control knob might not be in the ON position; turn it to ON.
A
Anthony JamesAug 26, 2025
What to do if the pilot won’t stay lit on my Hiland Premium F-1350-FPT?
- J
  johnsonlaurenAug 27, 2025
  If the pilot light won't stay lit, the issue could be due to: * Dirt built up around the pilot: Clean the dirt from around the pilot. * A loose connection between the gas valve and pilot assembly: Tighten the connection and perform a leak check. * A faulty thermocouple: Replace the thermocouple.
J
johnramosAug 27, 2025
What to do if my Hiland Patio Heater burner flame is low?
- K
  Kevin JohnsonAug 27, 2025
  If the burner flame is low on your Hiland Patio Heater, first turn the cylinder valve OFF and replace the cylinder. You may also need to use a full cylinder or check the burner and orifices for any blockages. Cleaning the burner and orifices might also resolve the issue.
J
Jennifer PorterSep 10, 2025
How to resolve air in the gas line of my Hiland Premium F-1350-FPT?
- P
  pnunezSep 12, 2025
  To resolve air in the gas line, open the gas line and bleed it by pressing the control knob in for no more than 1-2 minutes, or until you smell gas.
N
Natalie YoungSep 8, 2025
What to do if the igniter fails on my Hiland Premium F-1350-FPT?
- E
  Emily FieldsSep 8, 2025
  If the igniter fails, use a match to light the pilot. Obtain a new igniter and replace the old one.
T
Timothy ClarkSep 9, 2025
What to do if there is low gas pressure with a fully open cylinder valve on my Hiland Patio Heater?
- C
  Cody BaxterSep 9, 2025
  If you have low gas pressure even with the cylinder valve fully open, turn the cylinder valve OFF and replace the cylinder.
C
Charles TaylorSep 2, 2025
What to do if my Hiland Premium F-1350-FPT Patio Heater burner won't light?
- A
  Adam GarrisonSep 2, 2025
  If the burner on your Hiland Patio Heater isn't lighting, there are a few things to check. First, if the propane cylinder is frosted over, wait for it to warm up. Also, check for any blockages in the orifice and clear them. Finally, make sure the control knob is turned to the ON position.
N
Nicole HouseAug 31, 2025
Why won't the burner light on my Hiland Premium F-1350-FPT?
- A
  andersonchristopherSep 1, 2025
  If the burner on your Hiland Patio Heater won't light, it could be due to a frosted propane cylinder; wait until the propane cylinder warms up and becomes unfrosted. Also, check for any blockage and clear it. Ensure that the control knob is turned to the ON position.
A
Amanda ReyesSep 1, 2025
How to fix Hiland Premium F-1350-FPT pilot light that won't light?
- J
  Jennifer WilsonSep 2, 2025
  If the pilot light on your Hiland Patio Heater won't ignite, several factors could be at play. Start by checking for blockages in the orifice or pilot tube, and clean or replace them if necessary. Air in the gas line can also prevent ignition; bleed the gas line by pressing the control knob for no more than 1-2 minutes, or until you smell gas. Low gas pressure can be another culprit; if the cylinder valve is fully open, turn it OFF and replace the cylinder. Lastly, a faulty igniter can be the issue; try lighting the pilot with a match as a temporary solution, and replace the igniter.