Hiland HLDS032 - Assembly Instructions; Post-to-Housing Assembly; Base and Ring Weight Attachment; Emitter and Reflector Spacers

6
ASSEMBLY INSTRUCTIONS
Hardware Used
FF
GG
HH
II
Hardware Used
EE
Hardware Used
BB
DD
FF
1
2
3
TT
x 4
3/16 in. Stainless Bolts
x 1
M5X8 Bolt
x 1
Washer
x 1
M5 Nut
1. Attach post with burner assembly (G) onto heater
housing (H), using four 3/16 in. Stainless bolts (FF)
and M5X8 bolt (GG) M5 nut (II) washer (HH). Keep
the access panel (D) open.
2. Attach ring weight (F) to base (E) , using four
M6 X 20 bolts.
x 4
M6 X 20 Bolts
3. Put three reflector spacers (BB) into the holes in the
emitter (B). Use three nuts (DD) to hold the reflector
spacers inside of the emitter (B). Attach emitter (B) to
(G) using four bolts (FF).
x 3
Reflector spacers
x 3
Nuts
x 4
3/16 in. Stainless Bolts
G
FF
GG
HH
II
D
H
G
H
BB
B
DD
FF
G
E
F
EE