Hiland HLDS032 - Wire Guard Installation; Reflector to Emitter Attachment; Gas Cylinder Connection

7
ASSEMBLY INSTRUCTIONS
Hardware Used
AA
CC
4
5
6
4. Insert ends of wire guard (C) into holes in (G).
5. Put 3 washers (CC) into the top of support bolts.
Attach reflector to emitter assembly, using 3 nuts (AA)
and 3 washers (CC).
6. Rotate regulator toward opening in housing.
Line up threads on gas cylinder with those on the
regulator. Insert and rotate cylinder clockwise until
tight. Close (D).
x 3
Castle Nuts
x 6
Washers
C
G
AA
A
CC
D