To Next PageTo Next PageHow to fix carbon build-up and thick black smoke from my Hiland Patio Heater?
Carbon build-up and thick black smoke from your Hiland Patio Heater can be caused by dirt or film on the reflector and burner screen; clean the reflector and burner screen. Also, remove any blockage and clean the burner inside and outside.
What to do if my Hiland Premium pilot won’t light?
If the pilot light on your Hiland Patio Heater won't ignite, it could be due to a few reasons. There might be air in the gas line; open the gas line and bleed it (pressing control knob in) for no more than 1 - 2 minutes or until you smell gas. If the gas pressure is low with the cylinder valve fully open, turn the cylinder valve OFF and replace the cylinder. You can also try using a match to light the pilot, and consider obtaining a new igniter.
What to do if my Hiland Premium Patio Heater burner won’t light?
If the burner won't light, it could be due to several reasons. First, the propane cylinder might be frosted over; wait until it warms up. Second, there might be a blockage in the orifice; clear any blockage. Third, the control knob might not be in the ON position; turn it to ON.
What to do if the pilot won’t stay lit on my Hiland Patio Heater?
If the pilot light won't stay lit, the issue could be due to: * Dirt built up around the pilot: Clean the dirt from around the pilot. * A loose connection between the gas valve and pilot assembly: Tighten the connection and perform a leak check. * A faulty thermocouple: Replace the thermocouple.
What to do if my Hiland Premium Patio Heater burner flame is low?
If the burner flame is low on your Hiland Patio Heater, first turn the cylinder valve OFF and replace the cylinder. You may also need to use a full cylinder or check the burner and orifices for any blockages. Cleaning the burner and orifices might also resolve the issue.
How to resolve air in the gas line of my Hiland Patio Heater?
To resolve air in the gas line, open the gas line and bleed it by pressing the control knob in for no more than 1-2 minutes, or until you smell gas.
What to do if the igniter fails on my Hiland Premium Patio Heater?
If the igniter fails, use a match to light the pilot. Obtain a new igniter and replace the old one.
What to do if there is low gas pressure with a fully open cylinder valve on my Hiland Premium?
If you have low gas pressure even with the cylinder valve fully open, turn the cylinder valve OFF and replace the cylinder.
What to do if my Hiland Patio Heater burner won't light?
If the burner on your Hiland Patio Heater isn't lighting, there are a few things to check. First, if the propane cylinder is frosted over, wait for it to warm up. Also, check for any blockages in the orifice and clear them. Finally, make sure the control knob is turned to the ON position.
Why won't the burner light on my Hiland Patio Heater?
If the burner on your Hiland Patio Heater won't light, it could be due to a frosted propane cylinder; wait until the propane cylinder warms up and becomes unfrosted. Also, check for any blockage and clear it. Ensure that the control knob is turned to the ON position.
General| Type | Propane |
|---|---|
| Heat Output | 48, 000 BTU |
| Fuel Tank | 20 lb Propane Tank (not included) |
| Ignition | Piezo ignition |
| Material | Stainless Steel |
| Wheels | Yes |
