What to do if my Hillyard Floor Machine has no power?
If your Hillyard Floor Machine isn't powering on, there are several things to check: * Ensure the power cord is properly plugged in. * Check the building's circuit breaker and reset it if it has tripped. If these steps don't resolve the issue, it could be a faulty switch or power cord, in which case you should call for service.
Why won't the brush spin on my Hillyard Floor Machine?
If the brush on your Hillyard Floor Machine isn't spinning, try the following: 1. Make sure the brush switch is turned on. 2. Check if the brush circuit breaker has tripped and reset it if necessary. If the issue persists, the brush belt may be broken and need replacement, or the brush motor could be faulty, requiring service.
What to do if Hillyard TRIDENT EX12 Floor Machine vacuum motor runs but suction is poor?
If the vacuum motor of your Hillyard Floor Machine is running but the suction is poor, consider these possibilities: * There may be debris lodged in the vacuum shoe. Remove any obstructions. * The dome gasket could be defective or missing; replace it if needed. * Check the vacuum hose for cracks or a loose cuff; repair or replace as necessary. * The recovery tank might be full, or the float ball could be stuck. Turn off the vacuum motor and drain and rinse the recovery tank.
General| Brand | Hillyard |
|---|---|
| Model | TRIDENT EX12 |
| Category | Floor Machine |
| Language | English |
To Next Page
