20
Operations
4. Adjust handle to comfortable operating position.
Tip machine back by main handle to move to
starting point.
5. Lower machine to floor.
6. Select continuous setting to start solution spray or
select intermittent setting to enable use of trigger
switches to start solution spray.
The intermittent setting requires the operator to
hold any one of the three trigger switches in the
"on" position with the fingers, and is typically used
in small areas where short cleaning passes are
made.
The continuous setting allows the operator to set
the switch in the "on" position with one touch, and
is typically used in large areas where long cleaning
passes are made.
Cleaning Procedure
1. Start at wall closest to power outlet. Pull straight
back without pushing down on handle.
HIL56085 - Operators Manual - Trident EX8
To Next Page
Loading...
