*2194400*
2194400 Français 19
Trouble or fault Possible cause Action to be taken
Base plate cannot be
screwed fully into place.
The piston guide is clogged with
dirt behind the connecting thread.
▶ Clean the piston guide.
▶ Lubricate the connecting
thread.
The tool cannot be pressed
fully against the working sur-
face
The rotating sleeve is not fully
closed.
▶ Close the rotating sleeve.
→ page 11
The nail detector is jammed. ▶ Clean the base plate and
remove all foreign objects.
Take care to ensure adequate
lubrication of the fastener strip
guides with Hilti lubricant spray.
Part of the nail detector is broken. ▶ Check for correct operation of
the nail detector by checking
that the tool is ready for use
→ page 9.
No fasteners loaded in the tool ▶ Load the tool with fasteners.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
10 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
11 FCC statement (applicable in US) / IC statement (applicable in Canada)
This device complies with Part 15 of the FCC Rules and RSS-210 of lC. Operation is subject to the following
two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
12 Further information
For more information on operation, technology, environment and recycling, follow this link:
qr.hilti.com/manual?id=2194400&id=2194029
This link is also to be found at the end of the documentation, in the form of a QR code.
Notice d'utilisation originale
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi. C'est la condition
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
To Next Page
Loading...
Need help?
General
