11
2. Press the gas can clip to release the gas can.
3. Remove the gas can from the gas can compartment.
4. Fit the cap on the gas can.
5. Close the gas can compartment cover.
7.2 Unloading the magazine
1. Pull the nail pusher back until it engages.
2. Remove all nail strips from the magazine.
WARNING
Risk of pinching fingers! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
3. Release the nail pusher and guide it forward as far as it will go.
7.3 Removing the single-fastener adapter
▶ After driving the fasteners, remove the single-fastener adapter ( → page 12) from the fastening tool.
8 Optional operating steps
8.1 Checking the status of the gas can
1. Without pressing the fastening tool against the working surface, press the ‚GAS‘ button.
2. Read the gas can status from the display. → page 8
8.2 Removing the magazine
1. Pull the nail pusher back until it engages.
2. Remove the loose nail strips from the magazine.
WARNING
Risk of pinching fingers! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
3. Release the nail pusher and guide it forward as far as it will go.
4. Release the magazine locking catch.
5. Pivot the magazine about the pivot point towards the front.
6. Detach the magazine.
8.3 Fitting the magazine
1. Engage the front end of the magazine at the nose of the fastening tool.
2. Pivot the magazine towards the fastening tool.
3. Close the magazine locking catch.
8.4 Removing the fastener guide
1. Remove the gas can. → page 10
2. Move the fastener guide release slider to the «EJECT» position.
3. Remove the fastener guide.
8.5 Inserting the fastener guide
1. Remove the gas can. → page 10
2. Slide the fastener guide into the slot in the nose of the fastening tool.
3. Hold the fastener guide securely so that it cannot fall out and then press thenoseofthetool(i.e.the
tool with the fastener guide) against a firm surface until the fastener guide engages.
4. Check that the fastener guide has engaged.
◁ Once the fastener guide has engaged, the slider for releasing the fastener guide is again in the «+»
position.
To Next Page
Loading...
Need help?
General
