*2068470*
2068470 English 11
5.8 Measuring areas and volumes
5.8.1 Measuring rectangular areas
1. Aim the tool at the target point for the room width and press the
“Measure” button.
2. Aim the tool at the target point for the room length and press the
“Measure” button.
5.8.2 Measuring triangular areas
1. Aim the tool at the target point and press the “Measure” button.
2. Aim the tool at the target point and press the “Measure” button.
3. Aim the tool at the third target point and press the “Measure” button.
5.8.3 Measuring volumes
1. Aim the tool at the target point and press the “Measure” button.
2. Aim the tool at the next target point and press the “Measure” button.
3. Aim the tool at the next target point and press the “Measure” button.
5.8.4 Measuring cylindrical volume
1. Aim the tool at the corresponding target to measure the height of the
cylinder and press the “Measure” button.
2. Aim the tool at the next target point to measure the diameter of the
cylinder and press the “Measure” button.
5.9 Special functions
5.9.1 Automatic brightness sensor
▶ Select the symbol for the automatic brightness sensor from the special
functions menu.
The automatic brightness sensor automatically dims the lighting on
the display in dark surroundings. This saves battery power.
5.9.2 Painter’s area
1. Aim the tool at the target point for the first room length and press the
“Measure” button.
▶ The result is saved as an intermediate result.
2. Aim the tool at the target for the next room length and press the
“Measure” button to take the measurement.
▶ The second result is shown in the intermediate results table. The
intermediate result shown in bold is the sum of the measured room
lengths.
3. Repeat this procedure until all room lengths have been measured.
4. Press the right arrow button to switch to room height and confirm by
pressing the “Measure” button.
To Next Page
Loading...
