11. Manufacturer’s warranty
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or
inability to use the tool for any purpose. Implied
warranties of merchantability or fitness for a par-
ticular purpose are specifically excluded.
For repair or replacement, send the tool or related
parts immediately upon discovery of the defect to
the address of the local Hilti marketing organization
provided.
This constitutes Hilti’s entire obligation with regard
to warranty and supersedes all prior or contempor-
aneous comments and oral or written agreements
concerning warranties.
12. EC declaration of conformity
Designation:
Combilaser
Type:
PMC 46
Year of design:
2009
We declare, on our sole responsibility, that this
product complies with the following directives and
standards: 2004/108/EC, 2006/95/EC, EN 55014‑1,
EN 55014‑2, EN 61000‑6‑3, EN 61000‑6‑2.
Hilti Corporation
Bodo Baur Tassilo Deinzer
Quality Manager Head BU Measuring Systems
BA Electric Tools & Accessories BU Measuring Systems
03 2009 03 2009
en
23
To Next Page
Loading...
Need help?
General
