EasyManuals Logo

Hilti PMC 46 User Manual

Hilti PMC 46
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
5.4 Laser classification for laser class 2 / class
II appliances
Depending on the version purchased, the tool com-
plies with Laser Class 2 in accordance with IEC825-
3:2007 / EN60825-3:2007 and Class II in accordance
with CFR 21 § 1040 (FDA). This tool may be used
without need for further protective measures. The
eyelid closure reflex protects the eyes when a per-
son looks into the beam unintentionally for a brief
moment. This eyelid closure reflex, however, may be
negatively affected by medicines, alcohol or drugs.
Nevertheless, as with the sun, one should not look
directly into sources of bright light. Do not direct the
laser beam toward persons.
5.5 Electrical
a) Insulate or remove the batteries before shipping
the tool.
b) To avoid pollution of the environment, the tool
must be disposed of in accordance with the cur-
rently applicable national regulations. Consult
the manufacturer if you are unsure of how to
proceed.
c) Keep the batteries out of reach of children.
d) Do not allow the batteries to overheat and do not
expose them to fire. The batteries may explode or
release toxic substances.
e) Do not charge the batteries.
f) Do not solder the batteries into the tool.
g) Do not discharge the batteries by short circuiting
as this may cause them to overheat and present
a risk of personal injury (burns).
h) Do not attempt to open the batteries and do not
subject them to excessive mechanical stress.
i) Do not use damaged batteries.
j) Do not mix old and new batteries. Do not mix
batteries of different makes or types.
5.6 Liquids
Under abusive conditions, liquid may leak from the
battery. Avoid contact. If contact accidentally oc-
curs, flush with water. In the event of the liquid
coming into contact with the eyes, rinse the eyes
with plenty of water and consult a doctor. Liquid
ejected from the battery may cause irritation or burns.
6. Before use
6.1 Inserting the batteries 2
DANGER
Use only new batteries.
1. Remove the foot from the tool.
2. Open the battery compartment.
3. Remove the batteries from the packaging and
insert them in the tool.
NOTE Only batteries recommended by Hilti may
be used to power the tool.
4. Check that the battery terminals are positioned
correctly as shown on the underside of the unit.
5. Close the battery compartment cover. Check that
the catch engages properly.
6. Refit the foot to the tool.
7. Operation
NOTE
To achieve maximum accuracy, project the line onto
a vertical, even surface. When doing so, set up the
tool at 90° to the surface.
7.1 Operation
7.1.1 Switching the laser beams on
Press the on-button once.
7.1.2 Switching the tool / laser beams off
Press and hold the on-button until the laser beam is
no longer visible and the LED no longer lights.
en
18

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hilti PMC 46 and is the answer not in the manual?

Hilti PMC 46 Specifications

General IconGeneral
Laser ClassClass 2
Self-leveling Range±5°
Operating Temperature Range-10°C to +50°C
Battery Life20 h
IP Protection ClassIP54
Battery TypeAA Batteries

Related product manuals