This device complies with Part 15 of the FCC Rules and
RSS-210 of IC. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Information plates on the product:
-CAUTION-
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio com-
munications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment on and off, the user is encour-
aged to try to correct the interference by one or more of
the following measures:
● Re-orient or re-locate the receiving antenna.
● Increase the distance between the equipment and
receiver.
● Connect the equipment to an outlet on a circuit dif-
ferent from that to which the receiver is connected.
● Consult the dealer or an experienced TV/radio tech-
nician for assistance.
Changes or modifications not expressly approved by
Hilti could restrict the user's right to operate the equip-
ment.
12. FCC statement (applicable in US) / IC statement (applicable in Canada)
To Next Page
Loading...
