Hilti PR 30-HVSG A12 - Technical data; Technical data, rotating laser; Technical data, laser receiver

12 English
4.2 Technical data, laser receiver
Indicator range, distance from zero
±52 mm
Laser plane indication accuracy
±0.5 mm
Length of the detection area
≤ 120 mm
Center indication from top edge of casing
75 mm
Time without detection before automatic power off
15 min
Range of remote control unit (diameter) for the PR 30HVSG A12
2 m …150 m
Drop test height in the PRA 83 laser receiver holder (under stan-
dard ambient conditions in accordance with MILSTD810G)
2 m
Operating temperature
−20 ℃ …50 ℃
Storage temperature
−25 ℃ …60 ℃
Weight (including batteries)
0.25 kg
Protection class in accordance with IEC 60529 (except battery
compartment)
IP66
Maximum emitted transmission power
−0.2 dBm
Frequency
2,400 MHz …2,483.5 MHz
5 Operating the rotating laser
5.1 Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Handling the rotating laser and battery correctly
Note
The B12 battery has no protection class. Do not expose the battery to rain or wet conditions.
In accordance with the Hilti instructions, the battery may be used only with the associated product
and must be inserted in the battery compartment for this purpose.
1. Fig. 1: Working in horizontal mode.
2. Fig. 2: In inclined plane mode, the rotating laser should be lifted at the control panel side.
3. Fig. 3: Laying down or transporting in an inclined position. Working in the vertical plane.
◁ Hold the rotating laser so that the battery compartment does NOT face upwards, so that no moisture
can enter.
Printed: 29.09.2017 | Doc-Nr: PUB / 5376998 / 000 / 00