8 English
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.1.4 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself and others.
▶ Check that the belt hook is fitted securely before beginning work.
▶ Fit the belt hook.
➥ The belt hook allows the power tool to be attached close to the body on a belt worn by the operator.
The belt hook can be fitted to allow attachment on the left or right side of the body.
5.1.5 Fitting and adjusting the side handle
▶ Fit or adjust the side handle.
5.1.6 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.
Printed: 24.09.2018 | Doc-Nr: PUB / 5152424 / 000 / 05
To Next Page
Loading...
Need help?
General
