Hilti SF 22­A Manual

English 7
SF 22-A SFH 22-A
Ø drill bit (hardwood)
1.5 mm … 20 mm 1.5 mm … 20 mm
Ø drill bit (metal)
1.5 mm … 13 mm 1.5 mm … 13 mm
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
SF 22-A SFH 22-A
Emission sound pressure level (L
pA
)
75 dB(A) 96 dB(A)
Uncertainty for the sound pressure level (K
pA
)
3 dB(A) 3 dB(A)
Sound (power) level (L
WA
)
86 dB(A) 107 dB(A)
Uncertainty for the sound power level (K
WA
)
3 dB(A) 3 dB(A)
Total vibration
SF 22-A SFH 22-A
Vibration emission value for screwdriving (a
h
)
< 2.5 m/s² < 2.5 m/s²
Uncertainty for screwdriving (K)
1.5 m/s² 1.5 m/s²
Drilling in metal (a
h,D
)
< 2.5 m/s² < 2.5 m/s²
Uncertainty for drilling in metal (K)
1.5 m/s² 1.5 m/s²
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.1.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
Printed: 24.09.2018 | Doc-Nr: PUB / 5152424 / 000 / 05

Hilti SF 22­A Specifications

General

Brand	Hilti
Model	SF 22­A
Category	Drill
Language	English