14 English
1. Remove the battery from the power tool.
2. Secure the belt hook with 2 screws to the base of the power tool.
3. Check that belt hook and power tool are secure.
5.6 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck
firmly by hand until tight and several clicks are heard.
5. Check that the accessory tool is held securely.
6 Operation
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
Observe the safety instructions and warnings in this documentation and on
the product.
Printed: 02.05.2019 | Doc-Nr: PUB / 5152170 / 000 / 03
To Next Page
Loading...
Need help?
General
