Hilti SFC 14-A User Manual

10 English
▶ Push the battery into the tool from the rear until it engages with an audible click.
5.2 Removing the battery
▶ Remove the battery.
5.3 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.
5.4 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
5.5 Switching on
▶ Press the control switch.
Speed can be controlled steplessly right up to maximum by varying how far the control switch is
pressed in.
Printed: 11.09.2018 | Doc-Nr: PUB / 5152681 / 000 / 04

Hilti SFC 14-A Specifications

General

Number of gears	2
Screw diameter (max)	8 mm
Sound pressure level	69 dB
Idle speed (1st gear)	1700 RPM
Drilling diameter in wood (max)	20 mm
Drilling diameter in steel (max)	10 mm
Vibration level (metal drilling)	2 m/s²
Maximum torque (hard applications)	45 N⋅m
Maximum torque (soft applications)	24 N⋅m
Product color	Black, Red
Chuck type	Keyless
Product design	Pistol grip drill
Number of batteries included	1 pc(s)
Power source	Battery
Battery voltage	14 V

Weight and Dimensions

Weight	1500 g