*2253585*
2253585 Dansk 11
Trouble or fault Possible cause Action to be taken
All 4 LEDs flash.
The power tool does not
work.
The power tool has been over-
loaded.
▶ Release the control switch and
then press it again. Then allow
the power tool to run under no
load for approx. 30 seconds.
The power tool or battery
gets very hot.
Electrical fault ▶ Switch the power tool off im-
mediately, remove the battery,
keep it under observation, allow
it to cool down and contact Hilti
Service.
The power tool does not de-
velop full power.
A battery with inadequate capacity
was used.
▶ Use a battery with adequate
capacity.
Diminishing cutting perfor-
mance
Blade and / or cutting rails are
blunt.
▶ Change the blade. → page 9
▶ Change the cutting rails.
→ page 9
The motor has no braking
effect.
Low battery. ▶ Change the battery and charge
the empty battery.
The power tool was overloaded
briefly.
▶ Switch the power tool off and
then on again.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r10695219.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Original brugsanvisning
1 Oplysninger vedrørende dokumentationen
1.1 Vedrørende denne dokumentation
• Læs denne dokumentation igennem før ibrugtagning. Det er en forudsætning for sikkert arbejde og
korrekt håndtering.
• Følg sikkerheds- og advarselshenvisningerne i denne dokumentation og på produktet.
• Opbevar altid brugsanvisningen sammen med produktet, og overdrag det kun til andre personer sammen
med denne anvisning.
To Next Page
Loading...
Need help?
General
