Hilti TE 700-AVR User Manual (English)

Other manuals for Hilti TE 700-AVR

Operating Instructions24 pages

User Manual184 pages

Manual156 pages

Questions and Answers:

D
David SanchezSep 7, 2025
Que signifie le clignotement en rouge de l'indicateur de maintenance sur mon Hilti Power Hammer ?
- C
  cynthia54Sep 7, 2025
  Si l'indicateur de maintenance clignote en rouge sur votre Hilti Power Hammer, cela peut indiquer que la protection contre la surchauffe a été activée. Laissez refroidir l'appareil et nettoyez les ouïes d'aération. La marche à vide est encore possible. Une autre cause possible est que la tension de la source d'alimentation électrique est trop élevée. Essayez de changer de prise et de contrôler le réseau d'alimentation.
R
Rebecca RomeroSep 9, 2025
Que faire si mon burineur Hilti Power Hammer s'arrête en cours de fonctionnement ?
- J
  Juan WilliamsSep 9, 2025
  Si votre burineur Hilti Power Hammer s'arrête en cours de fonctionnement, la protection contre la surchauffe a peut-être été activée. Laissez refroidir l'appareil et nettoyez les ouïes d'aération. La marche à vide est encore possible.
A
amycoffeySep 12, 2025
Why doesn't my Hilti Power Tool breaker start?
- S
  samanthaloganSep 12, 2025
  If your Hilti Power Tool breaker doesn't start, it could be due to several reasons. First, the electronics might be initializing, which can take up to 4 seconds after plugging in. In this case, try switching the power tool off and then on again. Another reason could be the electronic restart interlock being activated after an interruption in the electric supply; again, switch the tool off and on. Check for a general interruption in the electric supply by plugging in another electric tool or appliance to see if it works. If you're using a generator, it might be in sleep mode; apply a load by connecting another device like a worklight, then switch the tool off and on. If none of these steps work, the tool might be faulty and should be repaired by Hilti Service.
A
Angelica HoganSep 12, 2025
What to do if my Hilti Power Tool breaker doesn’t achieve full power?
- A
  Alexandria HoltSep 12, 2025
  If your Hilti Power Tool breaker doesn’t achieve full power, there are a few potential causes. One possibility is that power reduction is active. To resolve this, press the power level selector switch, paying attention to the power level indicator. Additionally, try unplugging the power tool from the electric supply and then plugging it back in. Another cause could be that the extension cord is either too long or not thick enough (inadequate gauge). In this case, use an extension cord of an approved length and adequate gauge. Finally, the voltage provided by the electric supply might be too low. If this is the case, try connecting the power tool to a different power source.
L
Lori AllisonSep 14, 2025
Why does my Hilti Power Tool breaker switch off while running?
- M
  Maria FarleySep 14, 2025
  If your Hilti Power Tool breaker switches itself off while running, it's likely because the overheating prevention cut-out has been activated. To fix this, allow the tool to cool down and clean the air vents. Note that running under no load is still possible.

Hilti TE 700-AVR Specifications

General

Weight	7.9 kg
Single Impact Energy	11.5 J
Active Vibration Reduction	Yes
Service Indicator	Yes
Weight According to EPTA Procedure 01/2003	7.9 kg
Voltage	230 V
Frequency	50-60 Hz
Cord Length	4 m